*************************************************************************
*                        !!!!! ATTENTION !!!!!                          *
*************************************************************************
* For successful software upgrade, it is mandatory that you first       *
* install the latest boot loader file (s94bv10107.rfb file) which you   *
* can find in the Latest_Boot_Loader folder.                            *
*                                                                       *
* Verify that your switches are running the correct boot loader with    *
* the 'show version' command.  Once displayed, copy the boot version    *
* number exactly as shown. This number is the password you need to      *
* extract the ats94-30044.ros software upgrade file from the            *
* ats94-30044.zip file.                                                 *
*                                                                       *
* If your switch is not running the correct bootloader version, you     *
* will not be able to extract the ats94-30044.ros software upgrade file *
* and you must install the latest boot loader file provided.            *
*                                                                       *
* If you have a stacked configuration, all switches must be running     *
* the latest bootloader and the same software before you upgrade the    *
* software.                                                             *
*                                                                       *
* Note: if your switch is running software prior to v1.1.0.32, please   *
* refer to the SRN for version 3.0.0.35 on our ATI web site for upgarde *
* instructions.                                                         *
*************************************************************************
* If you accidently install this new software on a switch without the   *
* latest boot loader, the switch will fail to boot properly. To recover *
* from this situation, you must obtain a previous version of software   *
* (V3.0.0.35 or V3.0.0.38) from our ATI web site and perform the        *
* following procedure to install this software using the XMODEM         *
* protocol:                                                             *
*                                                                       *
* 1. Set up a console port connection.                                  *
* 2. Power cycle the switch.                                            *
* 3. Quickly press the Enter key when the switch displays the following *
*    line:                                                              *
*                                                                       *
* Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom. *
*                                                                       *
* 4. If you hit the Enter key quickly enough, the following Menu is     *
*    displayed:                                                         *
*                                                                       *
*          Startup Menu                                                 *
*                                                                       *
*      [1] Download Software                                            *
*      [2] Erase Flash File                                             *
*      [3] Enter Diagnostic Mode                                        *
*      [4] Set Terminal Baud-Rate                                       *
*      [5] Back                                                         *
*      Enter your choice or press 'ESC' to exit:                        *
*                                                                       *
* 5. Select number one by pressing the "1" key.                         *
*                                                                       *
*    The switch will respond with the following message:                *
*                                                                       *
*       Begin the transmission of a previous version.                   *
*       Downloading code using XMODEM.                                  *
*                                                                       *
* You may proceed with the xmodem transfer.                             *
* 6. When the download is complete reboot the switch, install the       *
* latest boot loader (s94bv10107.rfb) and this newest software.         *
*************************************************************************
